#CISCO PACKET TRACER TUTORIAL HOW TO#
#CISCO PACKET TRACER TUTORIAL SOFTWARE#
#CISCO PACKET TRACER TUTORIAL PASSWORD#
#CISCO PACKET TRACER TUTORIAL SIMULATOR#

IP address is the IP of network which will be advertise in OSPF and wild card mask will represent the network bits. Process-id is any number & must be same for all networks in AS. Network 192.168.88.0Д®nable OSPF routing on router. You can set a static route by using above command example is also given below: Router(config-router)# ip route [next-hop_address

#CISCO PACKET TRACER TUTORIAL HOW TO#

Router(config)# ip route 0.0.0.0 0.0.0.0 10.10.10.101 How to create a static route on Cisco router Router(config-if)#ip access-group 2 in How to configure the default route on Cisco:ДЇollowing command will set the default route to 10.10.10.101. Router(config)#interface fastEthernet 4/0 You can configure the access-list on cisco by using following commands: Router# copy running-config startup-config How to configure the access-list on Cisco: You can use the following command for router configuration to Nvram for use at next boot up You can use the вЂњ show ip interface briefвЂќ command in Privileged EXEC mode for checking the IP address of all interface of Cisco device. How to check the IP address of all interfaces:

Router(config-if)# ip address How to enable a port or interface You can set the IP address to any Cisco device interface by using the following commands: How to set the IP address to Cisco interface:

#CISCO PACKET TRACER TUTORIAL PASSWORD#

You can access the cisco router remotely by VTY lines, these are the Virtual Terminal lines for access router, you can set password on these line by using the following commands:ДЄbove command will set the telnet password to вЂњCiscoвЂќ. You can set the password for protecting enable mode by following command: (Following command will set the password to cisco) You can change the cisco router name by using command hostnameВ in global configuration mode. In any mode, you can obtain a list of commands available on that mode by entering a question mark (?). Therefore make sure you type it in correctly. IOS commands are not case sensitive it means that you can use them in uppercase, lowercase, or mixed case, but passwords are case sensitive. Press CTRL + CВ key combination during the first 60 seconds of booting process.

Use exitВ command to return in global modeД®nter reloadВ command from privileged exec mode. Use interface command from global configuration mode Use configure terminal command from privileged exec mode Use enableВ command from user exec mode for entering into this mode Also Check out some best cheap routers for real practice. Once you are at CLI you can perform all Cisco Commands here.Д¬isco IOS supports numerous command modes which can be practice with packet tracer, followings are the main command modes of cisco CLI with specific commands to navigate from one mode to another. You can do it by clicking any device and then navigating to CLI tab. To configure any device in packet tracer you are required to open or access its CLI. Related Article: PowerShell vs Command prompt

#CISCO PACKET TRACER TUTORIAL SOFTWARE#

There are also some other similar software but Cisco IOS output will be same on all simulators.

#CISCO PACKET TRACER TUTORIAL SIMULATOR#

Here is the detailed Cisco router configuration commands list, which can be implemented with packet tracer.В Packet tracer is a network simulator used for configuring and creating the virtual cisco devices and network.

Cisco packet tracer tutorial